收藏本站
Figure 17: Ultra DMA Data-Out Burst Device Pause Timing
Notes:
1.
2.
The device may negate DMARQ to request termination of the Ultra DMA burst no sooner than tRP after
-DDMARDY is negated.
After negating – DDMARDY, the device may receive zero, one, two, or three more data words from the host.
6.5.4.4.9 Device Terminating an Ultra DMA Data-Out Burst
The device terminates an Ultra DMA Data-Out burst by following the steps lettered below. The timing diagram for
the operation is shown in Figure 18: Ultra DMA Data-Out Burst Device Termination Timing. The timing parameters
are specified in Table 27: Ultra DMA Data Burst Timing Requirements and are described in Table 28: Ultra DMA Data
Burst Timing Descriptions.
The following steps shall occur in the order they are listed unless otherwise specifically allowed:
a) The device shall not initiate Ultra DMA burst termination until at least one data word of an Ultra DMA
burst has been transferred.
b) The device shall initiate Ultra DMA burst termination by negating – DDMARDY.
c) The host shall stop generating an HSTROBE edges within t RFS of the device negating – DDMARDY.
d) If the device negates – DDMARDY within t SR after the host has generated an HSTROBE edge, then the device
shall be prepared to receive zero or one additional data words. If the device negates – DDMARDY greater
than t SR after the host has generated anHSTROBE edge, then the device shall be prepared to receive zero,
one or two additional data words. The additional data words are a result of cable round trip delay and
tRFS timing for the host.
e) The device shall negate DMARQ no sooner than t RP after negating – DDMARDY. The device shall not assert
DMARQ again until after the Ultra DMA burst is terminated.
f)
The host shall assert STOP within t LI after the device has negated DMARQ. The host shall not negate STOP
again until after the Ultra DMA burst is terminated.
g) If HSTROBE is negated, the host shall assert HSTROBE within tLI after the device has negated DMARQ. No
data shall be transferred during this assertion. The device shall ignore this transition of HSTROBE. HSTROBE
shall remain asserted until the Ultra DMA burst is terminated.
h) The host shall place the result of its CRC calculation on D[15:00] (see 6.5.4.5 ).
i)
j)
The host shall negate – DMACK no sooner than t MLI after the host has asserted HSTROBE and STOP and the
device has negated DMARQ and – DDMARDY, and no sooner than t DVS after placing the result of its CRC
calculation on D[15:00].
The device shall latch the host’s CRC data from D[15:00] on the negating edge of – DMACK.
k) The device shall compare the CRC data received from the host with the results of its own CRC calculation. If
a miscompare error occurs during one or more Ultra DMA bursts for any one command.
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.20
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
C-320_data_sheet_CF-HxBO_Rev120.doc
Page 38 of 101
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
SFCF4096H4BK2SA-I-QT-553-SMA FLASH SLC UDMA/MDMA/PIO 4G
SFCF64GBH2BU4TO-I-NU-517-STD FLASH SLC UDMA/MDMA/PIO 64GB
SFN08B4702CBQLF7 RES ARRAY 47K OHM 7 RES 8-DFN
SFP1050-12BG FRONT END AC/DC 1050W 12V
SFP450-12BG PWR SUP 450W 12V 36.6A W/STANDBY
SFSD1024N1BN1TO-I-DF-151-STD FLASH MICRO SD CARD IND S-200 1G
SFSD2048L1BN2TO-I-DF-151-STD FLASH SECURE DGTL CARD SD 2G
SFSD4096L1BN2TO-I-Q2-141-STD FLASH SECURE DGTL CARD SDHC 4G
相关代理商/技术参数
SFCF2048H1BO2TO-I-M0-533-ZP1 制造商:SWISSBIT NA INC 功能描述:FLASH
SFCF2048H1BO2TO-I-M0-543-SMA 制造商:SWISSBIT NA INC 功能描述:FLASH
SFCF2048H2BU2TO-C-MS-527-STD 制造商:SWISSBIT NA INC 功能描述:FLASH
SFCF2048H2BU2TO-I-MS-517-STD 功能描述:FLASH SLC UDMA/MDMA/PIO 2GB RoHS:是 类别:存储卡，模块 >> 存储器，PC 卡 系列:C-440 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?
SFCF2048H2BU2TO-I-MS-527-STD 制造商:SWISSBIT NA INC 功能描述:FLASH
SFCF2048H4BK1SA-C-QT-553-SMA 制造商:SWISSBIT NA INC 功能描述:FLASH
SFCF2048H4BK1SA-I-QT-553-SMA 功能描述:FLASH SLC UDMA/MDMA/PIO 2G RoHS:是 类别:存储卡，模块 >> 存储器，PC 卡 系列:C-300 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?
SFCF2048H4BK2SA-C-DS-553-SMA 制造商:SWISSBIT NA INC 功能描述:FLASH SLC UDMA/MDMA/PIO 2G